Thread
:
The "Turtle Buster"
View Single Post
July 29, 2012, 10:55 AM
#
1
Beagle333
Senior Member
Join Date: January 7, 2012
Location: Auburn, AL.
Posts: 2,332
The "Turtle Buster"
I'm pretty excited about this new addition. This was a 358432 160gr mold that I had HP'd to make an awesome 137gr HP for just plinking cans or paper or turtles (if you got a problem with em
) I just got it back from getting the pins in it, so I haven't gotten to load any of em yet, but this looks really promising. The flat pin is so I can cast the original wadcutter as well.
I'll post some more info on performance after I get a chance to test it out, but I'm pretty excited to just have it.
Beagle333
View Public Profile
Find More Posts by Beagle333
Page generated in
0.03101
seconds with
8
queries