View Single Post
Old December 14, 2000, 10:28 PM   #1
BigPig
Member
 
Join Date: July 2, 1999
Posts: 93
Guys,

I did a search for this, and it was not very helpful.

I have 1,200 pieces (always adding to that number) of PMC .223 brass that I need to process, and I want a painless way to swage the primer pockets.

I have the RCBS primer pocket swager combo, but to be quite honest it is somewhat of a pain in the a** to use. I have done lots of 100 cases using it, and it takes forever, plus ends up leaving me with a pissed off feeling.

So basically is the Dillon WORTH the $80? I use A LOT of PMC ammo because its cheap and my buddies buy when they shoot my AR. The cases seem to hold up well, and I haven't broken any decapping pins on them either.

Anyway, I'd appreciate your input. I know about Dillon quailty, but I wanna know if this is worth my money. Thanks.
BigPig is offline  
 
Page generated in 0.02057 seconds with 8 queries