The Firing Line Forums - View Single Post

BigD_in_FL · July 22, 2013, 01:30 PM

If you open that feed tube "up a bit" you might make it so it does not hold the shells in the tube at all.

If has such a sharp edge that it is cutting, some sandpaper or similar on a dowel can be used to smooth it ever so slightly

July 22, 2013, 01:30 PM	#3
BigD_in_FL Junior member Join Date: December 20, 2012 Location: The "Gunshine State" Posts: 1,981	If you open that feed tube "up a bit" you might make it so it does not hold the shells in the tube at all. If has such a sharp edge that it is cutting, some sandpaper or similar on a dowel can be used to smooth it ever so slightly