I use a deep well socket just big enough so the case slides in and out easily which is chucked up in a battery operated drill spinning at low speed. I turn all the lights off except one small one behind me, then heat the middle of the neck with a small propane torch as it spins until I just start to see a dull red glow then just tilt the drill so the case falls into a bucket of water. The spinning creates a even heat , the socket acts a bit of a heat sink. I read of this technique over at one of the BR sites where they were interviewing one of the worlds top BR shooters and figure if it good enough for a world champ it is plenty good enough for this old hillbilly.
__________________
“How do I get to the next level?” Well, you get to the next level by being the first one on the range and the last one to leave.” – Jerry Miculek
|