About these 45 ACP Winchester cases. I don't think I explained the difference well. Since I cant send a Picture I will try to take some measurements. I took my basic DeWalt twist drill bit box with 29 bits from 1/16, 5/64, 3/32, 7/64, 1/8...
The smaller flash hole (standard size) is 5/64"
The seat or flat surface around the hole is very close to 5/64"<
The unusually large flash hole size is 1/8" witch if my calculations are correct is 3/64 larger than the standard flash holes.
The seat of flat surface around that hole is some thing less than 1/16" I'm guessing 3/64".
With what I have this is the best I can do.
|