View Single Post
Old September 23, 2009, 11:38 PM   #8
Model-P
Senior Member
 
Join Date: February 24, 2009
Posts: 727
Quote:
Next I am going to modify the firing pin to a thinner point so it will detonate the 45ACP primmers reliably.
Quote:
I am not a lawyer, but it is my understanding that if you do that, it might amount to Manufacturing a Firearm in the same manner as installing a loading gate on a regular c&b conversion.
This sounds like pure nonsense to me. Since when was simple gunsmithing ever the same thing as "manufacturing a firearm"?
Model-P is offline  
 
Page generated in 0.03001 seconds with 8 queries