Codyb1991, You could file those nubs off. I have on two of my own 700 plastic stocks. I then super-glued a thin leather pad back in the end of the channel. It made no difference either way. I did remove some material out of the side of the barrel channel as it looked like it was pressing on one side more than the other.
There's nothing wrong with those plastic stocks, if everything is fitting nice. My SPS will shoot occasional .5 MOA groups if I let the barrel cool between shots, and then it will shoot 15 consecutive rounds—hot—into about an inch or 1.15" with HP or BT (Vmax) factory ammo. 75 percent of those 15 rounds are inside of .75 MOA.
-SS-
|