The Firing Line Forums - View Single Post

Loader9 · December 12, 2008, 10:56 PM

Here's another problem for you, I have one of the last Hercules manuals and the 40 SW isn't in it...at all. I can tell you that Alliant turned up the heat on the current Unique powder so you should be good using current data for the old Unique. But you can't use the old data for the new Unique because it would be too hot at max loads. Got it?
Your load at 5.5 grs is not a max load and should be fine. I've loaded old Unique a lot heavier than your load from old data and it works fine.

December 12, 2008, 10:56 PM	#5
Loader9 Senior Member Join Date: July 29, 2008 Posts: 949	Here's another problem for you, I have one of the last Hercules manuals and the 40 SW isn't in it...at all. I can tell you that Alliant turned up the heat on the current Unique powder so you should be good using current data for the old Unique. But you can't use the old data for the new Unique because it would be too hot at max loads. Got it? Your load at 5.5 grs is not a max load and should be fine. I've loaded old Unique a lot heavier than your load from old data and it works fine.