The Firing Line Forums - View Single Post - Ruger 10-22 Trigger Job

Steve Koski · October 23, 1998, 01:44 PM

I've got the standard crappy trigger on my 10-22 and I'd like to improve it. I bought a new stock hammer (in case my dinking around doesn't come out right). I'm going to try and make the sear notch shallower and remove some material around the ball end (of the hammer). I'm going to try not to change the angle leading into the sear notch.

If you have done a job like this and have any suggestions I would love to hear them.

October 23, 1998, 01:44 PM	#1
Steve Koski Member Join Date: October 19, 1998 Location: Spanish Fork UT, USA Posts: 86	I've got the standard crappy trigger on my 10-22 and I'd like to improve it. I bought a new stock hammer (in case my dinking around doesn't come out right). I'm going to try and make the sear notch shallower and remove some material around the ball end (of the hammer). I'm going to try not to change the angle leading into the sear notch. If you have done a job like this and have any suggestions I would love to hear them.