View Single Post
Old July 28, 2010, 09:58 AM   #3195
invader
Junior Member
 
Join Date: July 28, 2010
Posts: 2
Good morning,

My boss came to me with an older revolver she wanted me to clean and spruce up. But, upon further looking, I left it alone. I think we have it narrowed down to an early 1960s J frame 31-1, but we're looking for a little more background information. She said it's been in the family for a while.

Model 31-1, blue
Square butt
.32 S&W Long
3" barrel
older hammer w/ hole and mounted riveted firing pin
No data on OEM grips, as this has a Pach set on it. She's still looking for the originals.
S/N H105XXX

Also, of note, are 2 other sets of numbers.
The one from the drop arm reads 78011, then has a G18 overstamped/stamped at the end.
The one from the side of the grip (left side) reads G1878011.
The "78011" for each set is a smaller deeper typeface, and the G18 is a lighter larger typeface. The G18 is just in 2 different positions depending on where it's stamped.

Thanks in advance
invader is offline  
 
Page generated in 0.02063 seconds with 8 queries