From my experience:
1. cannelure groove with strong roll crimp using soft copper plated bullets works "excellently". Great if you have to keep chambering the same ammo.
2. Strong roll crimp using soft copper plated bullets works "good" if you plan on shooting the ammo with a minimal amount of chamberings.
3. Light taper crimp and very light case belling works "OK" with a hard jacketed bullet if you plan on chambering the cartridge only once or so. Be careful to find a hard jacketed bullet that is compatible.
I just finished testing all three methods and put the details in my article, "357 SIG Safety & Reloading FAQ"
[Edited by petej88 on 12-11-2000 at 12:17 AM]
|