View Single Post
Old February 9, 2013, 08:38 AM   #107
Tactical Jackalope
Senior Member
 
Join Date: December 5, 2010
Location: Miami, Florida
Posts: 6,429
Thanks TR. I appreciate that greatly. I didn't know you had a P220! Love this thing.

I've taken the whole thing down and apart before. Just not the slide. I don't want to mess with it. (Internal extractor slides? I'm unfamiliar with)

Is it easy or hard to knock those pins out? I already have the pins and firing pin spring. I also really want to clean the extractor and firing pin. I don't think it's ever been done. Like the gun itself when I got it. You had to have seen the mess it was internally and it was still firing like a champ.

ImageUploadedByTapatalk1360416736.927770.jpg



Also. If I want to slap on night sights. Which I do... Would it be wise to just send it in to SIG? Breaks my heart having this gun away from me. It's my main CCW.

Or is it okay to just buy them and have a local SIG armored install them?



Oh and the serial number thing, I think I went to that site. And mine wasn't on there. Bit the one before and after were both the year 2000 so I'm assuming it was 2000. I could be wrong though. I want to see if someone else draws the same conclusion on that lol.


Thanks man. Appreciate it and again in advance.


Sent from my phone...expect typos.
Tactical Jackalope is offline  
 
Page generated in 0.04713 seconds with 9 queries