The Firing Line Forums - View Single Post

Zhillsauditor · May 23, 2013, 07:02 PM

The trick was to pull out the dust cover "nut", then move the bolt back to the punch hole and punch out the pin holding the locking block to the bolt.

However, I found that the firing pin was broken. Anyone have any leads on a replacement?

May 23, 2013, 07:02 PM	#8
Zhillsauditor Senior Member Join Date: October 19, 2008 Posts: 635	The trick was to pull out the dust cover "nut", then move the bolt back to the punch hole and punch out the pin holding the locking block to the bolt. However, I found that the firing pin was broken. Anyone have any leads on a replacement?