View Single Post
Old June 25, 2012, 09:00 PM   #13
DE Shooter
Senior Member
 
Join Date: January 20, 2009
Posts: 215
I usually plug the bore with a pipette bulb, pull the bolt, place barrel down in a plastic container, then fill the barrel to the chamber with hot tap water. Use a squirt bottle like for adding water to a battery. While the barrel is soaking, I run hot tap water over the bolt components and wipe them dry. Go back, drain the barrel, run a couple patches thru to dry, then do standard cleaning with Hoppes #9. I seldom get any water on the wood and if I do, I just wipe it off. All I shoot is corrosive spam can ammo...no rust problems.
DE Shooter is offline  
 
Page generated in 0.03138 seconds with 8 queries