.32acp
Just finished loading 350 >>> .32 acps
2.2 Titegroup under a 77 grain RN Hard Cast Lead. (National)
I didn't try to use my RCBSPiggyback or 650.
(Got the RCB Piggyback shell plate after I had already Sized, Primed, and flared them and the 650 conversion was too costly to justify for the small number I was reloading and intend to fire)
The .32 acp is a "carry a lot" > "Fire Few"
Did them single stage on a rockchuker.
Lee 3 Die Set and a .32 S&W Lee FCD with the crimp taken out (just used the carbide "resizing" ring.....Lee doesn't make a 32 acp FCD)
Flare just enough to start Bullet and crimp to remove the flare and return the case to resized diameter.
Have tried them in my 1903 Colt Model M and Model 1934 Beretta.
They worked fine in the 1903
Some were "tight" in the 1934.
I think the Bullet was engaging the "lands" in the Beretta before the round was completely chambered.
__________________
An Armed Society,
Is a Polite Society.
|