sinkers? for Slugging
Guys,
There is safety in asking...however I just spoke to Lee Precision's techie, and got the model numbers of two moulds that should fit. Also they dont need sizing according to him. Use liquid Alox. So I mosied over to Midway and ordered them; two cavity alum moulds with micro grooves and liquid alox. I know it aint' what we discussed. but after deciding to try slugging and looking at ammosmith.com there still were too many ?? like where do i slug the .357 mag.<ammosmith showed a revolver being slugged thru the chambers not the barrel. this worried me as on a dble action it could bend the crane. At that point I decided that at $20. each for the moulds I would be happy to try that and if I get leading I will adjust my thinking.
I was just about to try and slim down a sinker I have at .400" to fit. Maybe later.
Much obliged,
Last edited by max it; September 18, 2009 at 05:51 PM.
Reason: second thoughts
|