View Single Post
Old May 31, 2000, 12:49 PM   #7
Mal H
Staff
 
Join Date: March 20, 1999
Location: Somewhere in the woods of Northern Virginia
Posts: 16,939
Me neither. Think about it. For carbide dies, the carbide portion is short and has a slightly smaller ID than the remainder of the die well. For standard steel dies, the ID is considerably smaller than the ID of the crimp die. I suppose you could use the sizer die as a crimper but it would have to be rigged in a threaded sleeve so it could be raised an inch or so higher than normal - very impractical.
Mal H is offline  
 
Page generated in 0.03344 seconds with 8 queries