Thread: Project Mauser
View Single Post
Old February 27, 2009, 12:22 PM   #35
dburkhead
Senior Member
 
Join Date: March 10, 2008
Posts: 116
???

Where did I say anything about straightening the action? What I found, after finally getting the barrel off, was that the action (based on the flatness of the bottom) was still straight.

Incidentally, even with the action wrench and barrel vise I still could not get the barrel off. What I ended up doing was using the bench vise to hold the action wrench, using a pipe wrench on the barrel, and using a very long "cheater bar" on the pip wrench. Once I broke the initial bit free, it turned nicely and I could unscrew it by hand.

After that I checked that the bottom was straight against an optical bench we have here in the lab. Then when I got home, I trial fitted the trigger guard/magazine and that still fit nicely too. It does look like the action is still straight.
__________________
The award winning fantasy series "Heroes in Hell" returns this July with the new collection "Lawyers in Hell."
http://heroesinhell.wordpress.com/
Including a new story by David L. Burkhead
dburkhead is offline  
 
Page generated in 0.02182 seconds with 8 queries