View Single Post
Old September 11, 2012, 02:36 AM   #1
mohr308
Senior Member
 
Join Date: January 15, 2012
Location: Western New York
Posts: 466
Lee Perfect powder measure

So I pulled out my Lee ppm measure today so I could load a bunch of rounds. I loaded it with H335 and had that nice leakage that I'm not used to. Every throw was dead on, but I'm not happy with the few grains of powder that sneaks out every pull. I read the manual and it stated I could snug up the screw a little but not past 4 lb. of pull. Even with it tightened, it still would leak. Does anyone have any ideas on this fun situation or am I just stuck with it?
__________________
Lock and load, the zombies (democrats) are coming (to take your guns)!
mohr308 is offline  
 
Page generated in 0.04184 seconds with 8 queries