Don't know about "everybody", but I just like to tinker.
Maybe there's a 12-step program that can cure me, but I don't know of any offhand.
Anyway, past tinkering is the reason I wanted to replace the spring. With the Volq reduced power hammer spring I have installed, standard velocity loads will drive the bolt back hard enough to mark the recoil stop pin. Not a dent, just a mark and I'm not really concerned about it.
I did want to try a higher velocity load, so I figure a stronger recoil spring might be in order. I can always go back to the stock hammer spring if I have to, but like I said, I'm a degenerate tinkerer.
|