|
NO HAMMERS!!!
I just took one of mine apart and compared it to your picture.
Looks like the bolt and carrier are out of sync. Seems that somehow you have the carrier fully to the rear while the bolt is still somewhat forward. If that is correct then the bearing surfaces of the bolt are putting upward pressure (up being relative to the picture. ) on the bottom of the carrier binding it in the reciever raceway.
The reciever is as you know aluminum so if you put to much pressure on the carrier or bolt in a effort to move them back forward and into alignment you will RUIN something.
Be very careful if you use force. Tapping the carrier forward, or the bolt back, may allow then to drop back into alignment but to much tapping could be a disaster.
If you tap on them do it only gently........
|