|
AFAIK, that gun is the same as the Colt, so springs designated for Colts should work, possibly with a little fitting.
If you want to keep the original springs, You can work down the mainspring by grinding some off the sides, and tapering the spring slightly. The bolt/trigger spring can also be thinned and tapered a bit using a sanding drum on a Dremel tool.
Then take a bit off the hammer bolt cam so the spring arm does not have to bend so much.
Time the gun so that the bolt drops into the leade cut in the cylinder, and polish and slightly round the top of the bolt so it doesn't gouge the cylinder.
Jim
|