View Single Post
Old October 19, 2012, 09:50 AM   #10
Axelwik
Senior Member
 
Join Date: March 12, 2012
Location: Land of Enchantment
Posts: 436
If your bullets drop out of the cast at a good diameter and you're using them for light plinking loads just tumble them with some Alox.

If you don't want to spend a bunch on a lubrisizer, don't want to tumble lube, and don't want the mess of pan lubing there is another way.

This only works for soft lubes like 50/50 beeswax. I simply put a little lube on my finger and smear it into the lube grooves, then run the bullet through a Lee push-through sizer. It's a little slow, but it works great! It's also a good way to seat gas checks and lube all in one step.

Last edited by Axelwik; October 19, 2012 at 10:00 AM.
Axelwik is offline  
 
Page generated in 0.04525 seconds with 8 queries