The Firing Line Forums - View Single Post

Sport45 · May 21, 2012, 10:23 PM

It's in far enough if it presses the primers out. You don't want it up too high because there's not enough room for the neck between the neck sizing button and the neck sizing part of the die.

A little above flush is fine on my Lee dies.

May 21, 2012, 10:23 PM	#2
Sport45 Senior Member Join Date: May 25, 1999 Location: Too close to Houston Posts: 4,196	It's in far enough if it presses the primers out. You don't want it up too high because there's not enough room for the neck between the neck sizing button and the neck sizing part of the die. A little above flush is fine on my Lee dies. __________________ Proud member of the NRA and Texas State Rifle Association. Registered and active voter.