View Single Post
Old May 28, 2010, 04:00 AM   #2
ogree
Senior Member
 
Join Date: January 18, 2005
Location: Idaho
Posts: 151
The size of the reamer would be determined by the size and kind of the pins you are using.
I had to do that once, welded up the original holes, aligned the front sight and then re-drilled them using the front sight base as a guide....what a pain in the a** that was cause I didn't have a fixture specifically made for performing that operation.
If possible....I would send it back to the manufacturer and have them correct it, that is less of a hassle.
ogree is offline  
 
Page generated in 0.02793 seconds with 8 queries