The Firing Line Forums - View Single Post

kirkcdl · June 12, 2005, 04:51 PM

I own a K40,and I read somewhere that the"Elite"version of that gun had work done at the factory to shorten the otherwise longish trigger pull.I emailed Kahr and was told there was no way to do that.I think perhaps they were just doing a little CYA.I don't want to lighten the pull,just shorten it a bit.Anyone know how this is done?Perhaps by comparing side by side schematics of the two guns,and replacing parts that are different in the trigger mechanism?Ideas,anyone?Thanks in advance...

June 12, 2005, 04:51 PM	#1
kirkcdl Senior Member Join Date: December 14, 2002 Location: Roseburg,ORYGUN Posts: 821	Kahr K40 question I own a K40,and I read somewhere that the"Elite"version of that gun had work done at the factory to shorten the otherwise longish trigger pull.I emailed Kahr and was told there was no way to do that.I think perhaps they were just doing a little CYA.I don't want to lighten the pull,just shorten it a bit.Anyone know how this is done?Perhaps by comparing side by side schematics of the two guns,and replacing parts that are different in the trigger mechanism?Ideas,anyone?Thanks in advance...