Seat depth variance
Hi guys,
I recently ran a batch of 10mm loads on the 550. As a final check, I measured OAL of each round. Max OAL spec is 1.260. I usually seat to 1.257 OAL. This allows for different brands, shapes of bullets. I use medium range loads so no signs of excessive pressure.
When measuring the latest batch, actual OAL varied from 1.249 - 1.257. The seat die is tight, clean and hasn't been moved in the last several batches. I know 8 thousandths may not make a huge difference on many longer calibers, but after seating then .003 short of published max OAL, the .008 of slop is making me wonder a little. Is 1.249 possibly/probably too deep ?
How consistent are your seat dies ? Do any of you get such a variance ?
Thanks for the feedback
BigSlick
|