rodent, nice job on those conversions. Lookin' good.
Quote:
Originally Posted by Willie Sutton
I "think" that the swing-gate conversions will end up with a cylinder that is too short to be reamed to accept full length .460 brass loads... but that can be cured by trimming the cases. In which case you likely are just making the equal of Casull brass out of .460 brass.
|
I use
unmodified .460 S&W Magnum casings for the .45 BPM. You need every bit of that casing to fit 60 grains of FFFg in there. You can see a
video of the inaugural test firing of the .45 BPM in my converted Walker. Notice that I didn't feel like using my hand to test fire it until I gathered some data.