View Single Post
Old February 4, 2013, 08:47 PM   #10
Mobuck
Junior member
 
Join Date: February 2, 2010
Posts: 6,846
If you've been pounding on the pins for that long, quite possibly they're not coming out now w/o some serious effort. What are you using for a backing? A solid support and a good, straight impact with a suitable hammer "should" loosen the pins. Should and will are sometimes entirely different color horses. A machinist might be able to drill the pins out of the gas block leaving only a slight shell allowing removal.
Mobuck is offline  
 
Page generated in 0.02592 seconds with 8 queries