View Single Post
Old June 24, 2010, 04:18 PM   #9
schmeky
Senior Member
 
Join Date: February 11, 2006
Posts: 810
If you have a new sight from CZ, or the CZ Custom Shop, you will have to cut the roll pin groove on the underside of the sight. You can reuse the roll pin many times. A triangular file will work, but it's slow; a Dremel with a thin cut-off wheel works great, but go slow, real slow.

I've done this dozens of times.
schmeky is offline  
 
Page generated in 0.03349 seconds with 8 queries