The Firing Line Forums - View Single Post

Buckythebrewer · September 19, 2006, 07:46 PM

Azredhawk44 that is very intresting info.I am glad you mentioned it and I will keep an Eye on it if I change powder(I only use medium extruded h4895 for my ar15).The charge variations in most cases will happen when changing powders and thats why you should fill the measure and dump charges a bunch of times at least,refill then try your consistency.My measure is spot on every time I use it probably because I always use the same powder..What you say makes sense because I have seen the small h110 and h335 fall out the sides of the measure and if its getting by it must be doing damage when excessive pressure is against it(when charging).This is probably why I have had such good experience with the LEE measure because I have mostly only used small/medium extruded powder and didn't load enough of the small ball/flake powders to do damage.Sounds like a good theory to me,,Thanks for the info

.

September 19, 2006, 07:46 PM	#4
Buckythebrewer Junior member Join Date: April 15, 2006 Location: Jefferson, ME Posts: 700	Azredhawk44 that is very intresting info.I am glad you mentioned it and I will keep an Eye on it if I change powder(I only use medium extruded h4895 for my ar15).The charge variations in most cases will happen when changing powders and thats why you should fill the measure and dump charges a bunch of times at least,refill then try your consistency.My measure is spot on every time I use it probably because I always use the same powder..What you say makes sense because I have seen the small h110 and h335 fall out the sides of the measure and if its getting by it must be doing damage when excessive pressure is against it(when charging).This is probably why I have had such good experience with the LEE measure because I have mostly only used small/medium extruded powder and didn't load enough of the small ball/flake powders to do damage.Sounds like a good theory to me,,Thanks for the info.