View Single Post
Old June 24, 2011, 09:06 AM   #7
Marco Califo
Senior Member
 
Join Date: April 4, 2011
Location: LA (Greater Los Angeles Area)
Posts: 2,583
Quote:
I always decap (punch out the primer) after I have washed/cleaned the brass because I did not want to get dirt in my dies.
I use a Decapping Die from Lee before cleaning. This die does not touch the brass at all. Only the decapping pin touches the old primer.

Then, I clean the cases.

The exception is range brass or military once fireds. These go through a bucket of hot water with dishwashing detergent, and then rinsing before I touch them.
__________________
............
Marco Califo is offline  
 
Page generated in 0.02194 seconds with 8 queries