The Firing Line Forums - View Single Post

300winchester · August 17, 2012, 07:15 AM

Well I see alot !!! of blogs on this topic. Right out of the box problems for me. Read manual, tried 100 times to adjust cam wire. wont feed good in shell plate. After reading many articles, blogs , etc i noticed that the pawls are not tight ? they should be yes ? I think this might be and indexing issue on the shell plate not allowing my shells to go into the shell plate properly. Other question is , can I use a carbide rifle die without lube to do the deprime resize. I am also thinking of purchasing the Dillon RT 1200 case trimmer. any other case trimmers people are using would like to know about. Thanks all in advance. Loaded for 30 years on a single stage, so this progressive rifle is new to me.
thanks

August 17, 2012, 07:15 AM	#1
300winchester Junior Member Join Date: August 17, 2012 Posts: 2	Hornady AP case feeder issues Well I see alot !!! of blogs on this topic. Right out of the box problems for me. Read manual, tried 100 times to adjust cam wire. wont feed good in shell plate. After reading many articles, blogs , etc i noticed that the pawls are not tight ? they should be yes ? I think this might be and indexing issue on the shell plate not allowing my shells to go into the shell plate properly. Other question is , can I use a carbide rifle die without lube to do the deprime resize. I am also thinking of purchasing the Dillon RT 1200 case trimmer. any other case trimmers people are using would like to know about. Thanks all in advance. Loaded for 30 years on a single stage, so this progressive rifle is new to me. thanks