The Firing Line Forums - View Single Post

HisSoldier · December 17, 2011, 12:25 AM

Here is a photo, there is of course the normal place, then at the rear of the frame under the RH grip are two more, one right behind the grip screw hole and one just under the hammer pin. Notice that the one closer to the barrel is much smaller. My theory at this time is that the laser operator was testing the laser, but if others are also marked in those places then there must be another reason for it.

Thanks to anyone who can answer this mystery.

December 17, 2011, 12:25 AM	#2
HisSoldier Senior Member Join Date: August 9, 2007 Location: Oregoncoast Posts: 1,793	Here is a photo, there is of course the normal place, then at the rear of the frame under the RH grip are two more, one right behind the grip screw hole and one just under the hammer pin. Notice that the one closer to the barrel is much smaller. My theory at this time is that the laser operator was testing the laser, but if others are also marked in those places then there must be another reason for it. Thanks to anyone who can answer this mystery. __________________ CNC produced 416 stainless triggers to replace the plastic triggers on Colt Mustangs, Mustang Plus II's, MK IV Government .380's and Sig P238's and P938's. Plus Colt Mustang hardened 416 guide rods, and Llama .32 and .380 recoil spring buttons, checkered nicely and blued. Last edited by HisSoldier; December 17, 2011 at 12:32 AM.