The Firing Line Forums - View Single Post

kurmudgon · February 20, 2011, 07:33 PM

Boy, it's been a lot of years since I had mine.
The follower was held in by a steel pin that "followed" the grooves in the magazine body.
There was a round area at the end of the slot, on the bottom end, if I remember right. Slide the follower and pin down, then push the pin out the round hole.

I haven't seen any of the later ones. I heard they had plastic followers. The metal ones looked like they were a handful to manufacture.

Best, Kur

February 20, 2011, 07:33 PM	#2
kurmudgon Member Join Date: July 23, 2010 Location: East Central Minnesota Posts: 50	Boy, it's been a lot of years since I had mine. The follower was held in by a steel pin that "followed" the grooves in the magazine body. There was a round area at the end of the slot, on the bottom end, if I remember right. Slide the follower and pin down, then push the pin out the round hole. I haven't seen any of the later ones. I heard they had plastic followers. The metal ones looked like they were a handful to manufacture. Best, Kur __________________ When I die I'm going straight to Heaven, 'cause I served my time at Coonan Arms.