The Firing Line Forums - View Single Post

CPTMurdoc30 · April 17, 2008, 01:05 PM

I have used my hammer bullet puller as a hammer a few times. Not a single problem here. I normaly smck it on a piece of angle iron I have one press mounted to. This is not a high volume operation as after about 10 my hand hurts for about 4 hours.

I would just get the Hornady or RCBS collet pullers. If done right they doo less damage than a hammer type to some bullets (Soft points).

April 17, 2008, 01:05 PM	#23
CPTMurdoc30 Senior Member Join Date: February 27, 2008 Location: Stafford VA Posts: 969	I have used my hammer bullet puller as a hammer a few times. Not a single problem here. I normaly smck it on a piece of angle iron I have one press mounted to. This is not a high volume operation as after about 10 my hand hurts for about 4 hours. I would just get the Hornady or RCBS collet pullers. If done right they doo less damage than a hammer type to some bullets (Soft points). __________________ Solving Virginia's Ground Hog problems 50gr at a time.....