The Firing Line Forums - View Single Post

John22 · September 17, 2001, 06:27 AM

I installed the Power Custom Free Spin Pawl in my SBH ... NICE ... It comes with very good instructions and it drops right in. The only adjustment I made was to de-burr the edges. Not that there was any real burr there but more to break the sharp edges on the sides (snag prevention). Whith this installed the cylinder will spin freely either direction with no clicking sounds. The instructions warn you that some mechanical ability is required. So if you are not all thumbs you should be ok as long as you can take it apart and re-assemble it in one sitting.

September 17, 2001, 06:27 AM	#8
John22 Member Join Date: July 24, 2001 Location: Seacoast NH Posts: 39	I installed the Power Custom Free Spin Pawl in my SBH ... NICE ... It comes with very good instructions and it drops right in. The only adjustment I made was to de-burr the edges. Not that there was any real burr there but more to break the sharp edges on the sides (snag prevention). Whith this installed the cylinder will spin freely either direction with no clicking sounds. The instructions warn you that some mechanical ability is required. So if you are not all thumbs you should be ok as long as you can take it apart and re-assemble it in one sitting. __________________ Deus Regnat Exultet Terra