Thread
:
S&W Model 36 - cylinder release - does not want to release
View Single Post
July 7, 2012, 01:52 PM
#
3
Yankee Doodle
Senior Member
Join Date: December 5, 2004
Posts: 619
Tighten the ejector. Remember to put a couple of empty cases into the cylinder before you tighten the rod. This will prevent the extractor star form being torqued out of alignment.
This will cure the problem >99% of the time.
Yankee Doodle
View Public Profile
Find More Posts by Yankee Doodle
Page generated in
0.03332
seconds with
8
queries