View Single Post
Old June 15, 2007, 06:46 PM   #1
jclayto
Senior Member
 
Join Date: February 14, 2005
Location: Anderson, SC
Posts: 600
Problem with Lee 4 Hole Turret.

I have just set up my lee 4 hole turret. With no dies installed in the turret and making sure that I move the handle all the way up and down with each turn, the turret seems to get out of line about every 7th or 8th pull. (out of line meaning the shell holder ends up night lining up with the turret hole) Do you have any suggestions on what could cause this?


Also, are the seating die and the sizing die the same die? I have dies with the same label in my 4 die set.


Thanks!
Jonathan
jclayto is offline  
 
Page generated in 0.03611 seconds with 8 queries