View Single Post
Old June 9, 2014, 07:27 PM   #22
mehavey
Senior Member
 
Join Date: June 17, 2010
Location: Virginia
Posts: 6,869
Quote:
> With the crimping die, I used a factory round that I know operates well,
> in the shell holder and ran it up. I slowly threaded in the die until it made
> contact, then did the same with the center rod that sets bullet depth.
> Then slowly adjusted from there until I got the same OAL as the factory round.
Potentially dumb question:

- Are you crimping and seating all in the same ram stroke ?
mehavey is offline  
 
Page generated in 0.03630 seconds with 8 queries