The Firing Line Forums - View Single Post - Full Wad Cutter vs. Semi-Wad Cutter

melchloboo · November 28, 2008, 08:36 PM

If you are shooting revolver there may be some difference because the full wad cutter has more bearing surface.

I have heard stories of shooters seating wad cutters not flush, but leaving a tip out to slide up the ramp. I have never actually seen it, nor would I try it myself.

November 28, 2008, 08:36 PM	#3
melchloboo Senior Member Join Date: October 2, 2008 Posts: 279	If you are shooting revolver there may be some difference because the full wad cutter has more bearing surface. I have heard stories of shooters seating wad cutters not flush, but leaving a tip out to slide up the ramp. I have never actually seen it, nor would I try it myself.