Thread
:
Bent Cylinder Yoke/Crane
View Single Post
July 9, 1999, 11:04 PM
#
2
George Stringer
Staff Alumnus
Join Date: October 12, 1998
Location: Earlington KY
Posts: 2,299
Grenadier2, a gunsmith who works on revolvers will have a specilized tool to straighten the crane. I wouldn't begin to try it without the right equipment. There are a lot of smiths around who do this type of work including me. George
George Stringer
View Public Profile
Visit George Stringer's homepage!
Find More Posts by George Stringer
Page generated in
0.03193
seconds with
8
queries