10 22 bolt dragging with BX-25ers only
I have a newer (bought new) 10/22fs that works just fine with 10 round Ruger mags. The minute that I run a BX-25 (any of several) the bolt drags across the top of the mag (near the feed lips) and slows the bolt to the point of failure to feed.
Yes, I have disassembled the entire rifle and cleaned it.
Yes, this is not my first 10/22; have had a number over the years.
Yes, the BX-25 mags work in different 10/22s.
I am wondering if there is a designed dimensional difference between the 10 and 25 round mags, on the top of the mag (guessing not, but one never knows until...); I haven't measured, yet there are drag marks on the 25ers.
Anyone else have this issue? And/Or possible remedies? I am considering polishing the bolt where it interfaces with the BXs. I would prefer not to have to send it back to the mothership/Ruger if possible.
Just another item on an unending "Todo" list for the day...
__________________
The lowest paid college major/degree in this country after graduation...
Elementary Education.
Now, go figure...
|