Quote:
|
Since I don't resize my 9mm, I pan lube them. It's faster than using the Lyman 450 because I do 600 at a time using 6 small silicone pans that hold 100 each.
|
I would like to see a comparison of processing (sizing and lubing), the same number of bullets using a Lyman 450. By the time you place each bullet in the pans, fool around with the heating/pouring the lube, cutting the bullets out with a kake-cutter (I presume), I suspect that there would be little if any time savings. Being an old punch-press operator, I can go pretty darn fast. I pick-up a bullet to be sized with my left hand at the same time I am removing the sized/lubed bullet with my right...you learn little tricks like that when you are working on "piece-rate" in a factory.