Thread: Tube feeder?
View Single Post
Old February 10, 2013, 08:15 PM   #1
J2.
Senior Member
 
Join Date: June 12, 2008
Location: The Real America
Posts: 149
Tube feeder?

I was discussing them with a friend when he mentioned he was going to polish the inside of the tube on a new Rossi Lever he just purchased, along with that he said he would do the spring as well. We also talked about the spring tension on the loading door. Can/should this be lessened?

What are your thoughts?
__________________
"Those who hammer their guns into plows will plow for those who do not."
J2. is offline  
 
Page generated in 0.02281 seconds with 8 queries