The Firing Line Forums - View Single Post

4T4MAG · January 16, 2013, 03:35 PM

I have a question on my AR15 DPMS single stage trigger. With the upper removed, with the hammer cocked, when I gently pull the trigger with out firing, the hammer is slightly pulled back/down also. The is a standard DPMS single stage FCG with standard springs. Should the hammer be pulling back/down more when I pull the trigger? I am wondering if the angles of the trigger and hammer are off or it it just needs some flitz? The trigger pull is sticky and spongy. I can post a pict if this does not make sense.

January 16, 2013, 03:35 PM	#1
4T4MAG Senior Member Join Date: April 28, 2009 Posts: 162	AR15 DPMS Trigger/Hammer I have a question on my AR15 DPMS single stage trigger. With the upper removed, with the hammer cocked, when I gently pull the trigger with out firing, the hammer is slightly pulled back/down also. The is a standard DPMS single stage FCG with standard springs. Should the hammer be pulling back/down more when I pull the trigger? I am wondering if the angles of the trigger and hammer are off or it it just needs some flitz? The trigger pull is sticky and spongy. I can post a pict if this does not make sense.