View Single Post
Old February 8, 2000, 08:19 PM   #2
Wallew
Junior member
 
Join Date: October 3, 1999
Posts: 910
You might consider just polishing the insides of the cylinder. You didn't state whether the pistol was new or used. I assume used. You can get a build up of 'crud' on the inside of the cylinder walls over years of usage. This could be causing the problem. If new, send that sucker back to the manufacturer. I would be greatly surprised if the cylinder was not correctly bored. But you never know. Jim
Wallew is offline  
 
Page generated in 0.03339 seconds with 8 queries