View Single Post
Old August 18, 2012, 01:32 PM   #3
billcarey
Senior Member
 
Join Date: February 3, 2009
Location: Florida
Posts: 273
I use an early Hornady trickler, much simplier. These are easily made. Look at the RCBS trickler as a guide. Substitute the metal body with a 1-1/2" diameter of PVC pipe. Plug one end with a slug of lead (or whatever is solid and heavy) to maintain balance. Drill a hole in the center with clearance for a small trickle tube. Use o-rings on each side of the tube to keep it centered and powder from leaking. Drill one small hole in the center of the tube for powder to exit through. Plug one end of the tube where your fingers grab. Leave the other end open for the powder to trickle out into your pan.
billcarey is offline  
 
Page generated in 0.03662 seconds with 8 queries