View Single Post
Old August 21, 2001, 02:17 PM   #7
JohnK
Senior Member
 
Join Date: May 12, 2001
Location: Duvall, Wa
Posts: 552
It depends is a good answer based on your question. I never use gas checked bullets in my magnum revolvers, haven't yet had a need to. One point I want to make, because from your question I'm not sure you know this, you can't put gas checks on any old hard cast bullet. The bullet has to be a design that uses gas checks.

In 357 magnum you're not likely to be pushing 180gr bullets fast enough to require gas checked bullets as long as you pick bullets cast from a decent alloy. Leadhead or Penn Bullets would be good sources for reasonably priced hard cast bullets that don't require a gas check.
__________________
John

http://www.handloads.com
Molan Labe!
JohnK is offline  
 
Page generated in 0.03530 seconds with 8 queries