Thread: Cleaning Dies.
View Single Post
Old October 28, 2012, 05:56 AM   #12
Bart B.
Senior Member
 
Join Date: February 15, 2009
Posts: 8,927
Naptha's what I use.

Then every once in a while I put some 600 grit abrasive on a rag, wrap it around a bore brush chucked in an electric drill than use it to polish the inside of the dies. What ever amount of metal's removed is negligible as far as changing dimensions is concerned. But those polished dies sure make full length sizing easier. And cases are shinier, too.
Bart B. is offline  
 
Page generated in 0.03315 seconds with 8 queries